1. Set the if_network parameter to true.
sc> setsc if_network true
2. Set the if_connection parameter to the connection type, either telnet or ssh.
sc> setsc if_connection value
where the value can be one of the following:
■
none
telnet
■
■
ssh
netsc_dhcp (The system controller obtains its network interface configuration
■
through a DHCP server.)
See the Advanced Lights Out Management (ALOM) CMT Guide for more information
about SSH support in ALOM CMT.
3. Choose one of these methods to configure the system controller using information
from your network administrator:
Use DHCP to retrieve the network settings. Go to
■
Configure a static IP configuration. Go to
■
4. If you choose to use DHCP, set netsc_dhcp to true.
sc> setsc netsc_dhcp true
Go to
5. If you choose to use a static IP configuration, set the parameters netsc_ipaddr,
netsc_ipgateway, and netsc_ipnetmask, as follows.
a. Set the IP address for the system controller.
sc> setsc netsc_ipaddr service-processor-IPaddr
b. Set the IP address for the system controller gateway.
sc> setsc netsc_ipgateway gateway-IPaddr
40
SPARC Enterprise T2000 Server Installation Guide • April 2007
Step
6.
Step
4.
Step
5.