To Configure The System Controller Network Management Port - Fujitsu Sparc Enterprise T2000 Installation Manual

After the admin password has been set, on subsequent reboots, the sc login prompt
is displayed.
2. Enter admin for the login name followed by your password.
TTYD - - PASSED
TTYC - - PASSED
MEMORY - - PASSED
MPC885 - - PASSED
Please login: admin
Please Enter password: password
(Press Return twice)
sc>
▼ To Configure the System Controller Network
Management Port
Note – If your network allows the use of DHCP and SSH, this configuration is
performed automatically at the first time you boot the system.
Use this procedure only if:
If you are unable to use DHCP and SSH on your network.
■
If you need to modify the SC network management port settings.
■
In this procedure you connect to the ALOM CMT system controller using the serial
management port to manually reconfigure the network management port.
Note – For more information on configuring ALOM CMT, refer to the Advanced
Lights Out Management (ALOM) CMT 1.x Guide.
You set these network parameters according to the specific details of your network
configuration:
if_network – Specifies whether the SC is on the network or not
■
netsc_ipaddr – IP address of the system controller
■
netsc_ipgateway – IP address of the gateway for the subnet
■
netsc_ipnetmask – Netmask for the system controller subnet
■
To configure these parameters, use the setsc command. The usage is:
sc> setsc parameter
Chapter 3 Powering On the System 39