Fujitsu Sparc Enterprise T2000 Installation Manual page 30

6. Connect the data cables to the server, but do not connect the AC power cable yet.
See
7. Connect the AC power cable to the server and examine the display for any error
messages. See
Caution – There is a potential for electric shock if the server and related equipment
are not properly grounded.
Note – The system controller (SC) runs on the 3.3v standby voltage. As soon as AC
power is connected to the system, the system controller immediately powers on,
runs diagnostics, and initializes the ALOM CMT firmware.
8. After the system controller boots, access the ALOM CMT command line interface
through the serial management port. See
Using the Serial Management Port" on page
9. Configure the SC network addresses. See
Network Management Port" on page
Note – The SC network management port is not operational until you configure
network settings for the system controller (through the SC serial management port).
10. Enable the new configuration by resetting the system controller. See
the System Controller" on page
11. Power on the server from a keyboard using the ALOM CMT software. See
Power On the System" on page
12. Configure the Solaris™ OS. See
page
The Solaris OS is preinstalled on the SPARC Enterprise T2000 server. When you
power on, you are automatically guided through the Solaris OS configuration
procedure.
13. Install any required patch or patches to the server.
Refer to the SPARC Enterprise T2000 Server Product Notes for a list of the required
patches.
14. Load additional software from the Solaris media kit (optional).
4 SPARC Enterprise T2000 Server Installation Guide • April 2007
"Connecting Cables to the Server" on page
"Powering On the System for the First Time" on page
46.
25.
"To Log Into the System Controller
38.
"To Configure the System Controller
39.
42.
44.
"Booting the Solaris Operating System" on
33.
"To Reset
"To