2. Open a Telnet or SSH session and connect to the system controller.
The following example is for Telnet.
% telnet xxx.xxx.xx.xx
Trying xxx.xxx.xx.xx...
Connected to xxx.xxx.xx.xx.
Escape character is'^]'.
Use is subject to license terms.
Advanced Lights Out Manager CMT v1.x
Please login:
3. Login as admin, using the password you defined during the configuration of
the system controller.
Please login: admin
Please Enter password: password
sc>
4. Execute the flashupdate command.
The flashupdate SC command updates the system controller flash image and the
host firmware. The flashupdate command requires the following information:
IP address of an FTP server on the network that can access the flash image.
■
Full path name to the flash image that the IP address can access.
■
Username and password of an account registered on the system that is specified by the IP
■
address.
The command usage is as follows:
flashupdate [-s IPaddr -f pathname] [-v]
where:
-s IPaddr is the IP address of any FTP server on the network that can access the
■
flash image
-f pathname is the full path name to the flash image
■
52
SPARC Enterprise T2000 Server Installation Guide • April 2007