Installation - EverFocus EQ610s User Manual

6) Down-scroll button
7) Video Output Connector
BNC connector that connects to a 75 Ohm coaxial cable to feed the
video output of the camera to a color monitor or other video devices.
8) Power Input Terminal
Connects to the appropriate power source (12 VDC / 24 VAC~ or
90-260 VAC~).
9) Auto Iris Lens Connector
This connector is used to connect to an auto iris lens via a 4-pin male
connector.
Direct Drive

3 INSTALLATION

1. Unscrew the protection cap from the mouth of the lens
mounting.
2. If a C-mount lens is to be used, please screw the C-mount
adaptor ring (the 5mm-thick ring in the accessory pack) on to
the mouth of the lens mounting.
3. Mount the lens by turning it clockwise on the lens mounting of
the camera.
4. If you use an Auto Iris lens, connect the lens's cable to the
Auto Iris lens connector on the side of the camera.
5. Place an ND filter in front of the lens, adjust the lens focus
until the best image is obtained.
6. Lock the lens's focus position by tightening the swivel screw,
and then remove the ND filter.
Mount the lens
Pin1 Pin2
Cnt- Cnt+
Pin3 Pin4
Drv+ Drv-
5
EQ610s