Loading Lens Files Automatically - Sony PMW-500 Operation Manual

To cancel the load, select [Cancel], and
then press the MENU knob.
If you select [Execute], a list box of lens files
appears. File numbers where "No File" is
displayed are empty file numbers.
4
Select the desired file number, and then
press the MENU knob.
A confirmation message appears.
5
To execute the load, select [Execute],
and then press the MENU knob.
To cancel the load, select [Cancel], and
then press the MENU knob.
If you selected Lens Recall S×S in step 2, the
ACCESS lamp lights (in blue on the right-
side panel and in orange in the card slot
section) when you execute the load.
When the specified lens file has been loaded
from the S×S memory card, a completion
message appears and the ACCESS lamp goes
out.

Loading Lens Files Automatically

When you are using a lens that support serial
communication, you can set up the camcorder by
automatically loading the lens file that
corresponds to the lens settings (Lens Auto Recall
function).
To use the Lens Auto Recall function, set FILE
>Lens >Lens Auto Recall in the setup menu to
one of the following.
On: Load the lens file that corresponds to the
model name.
Off: Do not use the Lens Auto Recall function.
Serial Number: Load the lens file that
corresponds to the model name and serial
number (when the lens supports
communication of the serial number).
If the lens does not support communication of the
serial number, both settings load the lens file that
corresponds to the model name.
144 Saving and Loading Lens Files