Accessory Attachments - Sony PMW-500 Operation Manual
Solid-state memory camcorder
Hide thumbs
Also See for PMW-500:
- Operation manual (203 pages) ,
- Operator's manual (35 pages) ,
- Manual (13 pages)
Table of Contents
Advertisement
c DC IN (DC power input) connector
(XLR type, 4-pin, male)
To operate the camcorder from an AC power
supply, connect an optional DC power cord to this
terminal and then connect the cord to the DC
output terminal of the BC-L70, BC-L160, or
another battery charger.
d DC OUT 12V (DC power output)
connector (4-pin, female)
Supplies power for an optional WRR-860C/861/
862 UHF Synthesized Diversity Tuner
(maximum 0.5 A).
Note
Do not connect any equipment other than the UHF
synthesized diversity tuner.
e Battery attachment shoe
Attach a BP-GL95/GL65/L80S/L60S Battery
Pack. Alternatively, you can attach an AC-
DN2B/DN10 AC Adaptor to operate the
camcorder on AC power supply.
For details, see “Preparing a Power Supply”
(page 32).
For details, see “Attaching a UHF Portable Tuner
(for a UHF Wireless Microphone System)”
(page 42).
Note
For your safety, and to ensure proper operation of the
camcorder, Sony recommends the use of the following
battery packs: BP-GL95, BP-GL65, BP-L60S, and
BP-L80S.
Camera adaptor connector
Enables connection of a camera adaptor. To
connect a camera adaptor, remove the cover from
the connector and install the optional CBK-HD02
SDI/COMPOSITE Input and 50 Pin Interface.
Accessory Attachments
a Shoulder strap fitting
Attach the supplied shoulder strap (see page 46).
b Accessory fitting shoe
Attach an optional accessory such as a video light
(see page 46).
c Viewfinder front-to-back positioning
lever
To adjust the viewfinder position in the front-to-
back direction, loosen this lever and the LOCK
knob. After adjustment, retighten this lever and
the LOCK knob.
d Viewfinder left-to-right positioning ring
Loosen this ring to adjust the left-to-right position
of the viewfinder (see page 34).
e Viewfinder fitting shoe
Attach the viewfinder.
f VF (viewfinder) connectors (26-pin,
rectangular and 20-pin, round)
The analog interface connector (20-pin) is for
connection of a HD viewfinder, and the digital
interface connector (26-pin) is for connection of a
1)
PMW viewfinder.
Use a connection cable to connect your
viewfinder to the corresponding connector.
1) The CBK-VF01 PMW Viewfinder will be available
from March 2011.
Page 14
Advertisement
Table of Contents
