from the time you were conducting playback or a
recording review.
To select picture cache mode and set the picture
cache time
Notes
• Picture cache recording is not possible in Frame Rec,
Interval Rec, Slow & Quick Motion, and Clip
Continuous Rec mode. The camcorder exits Frame
Rec, Interval Rec, Slow & Quick Motion or Clip
Continuous Rec mode, whenever you select picture
cache mode. The camcorder exits picture cache mode
automatically whenever you select Frame Rec,
Interval Rec, Slow & Quick Motion, or Clip
Continuous Rec mode.
• The data stored in picture cache memory is cleared
when you change the system settings, for example by
selecting a different video format. Picture data from
before the change is not recorded even if you start
recording immediately after the change. The
camcorder exits picture cache mode automatically.
• It is not possible to set the picture cache time during
recording.
1
In the setup menu, select OPERATION
>Rec Function >Picture Cache Rec.
For menu operations, see “Basic Setup Menu
Operations” (page 98).
2
Turn the MENU knob to select [On],
and then press the knob.
3
Select [P. Cache Rec Time], turn the
MENU knob to select the desired
picture cache time, and then press the
knob.
You can select from 0-2sec, 2-4sec, 4-6sec,
6-8sec, 8-10sec, 10-12sec, 12-14sec, and
13-15sec.
Once made, picture cache mode settings remain
in effect until changed.
1
and 2, you can also
Instead of carrying out steps
select picture cache mode by using an assignable
switch to which the Picture Cache function has
been assigned (see page 136).
Camcorder data handling while recording in
picture cache mode
Recording procedures in picture cache mode are
basically the same as normal recording
procedures. However, note the following
differences with respect to how the camcorder
handles video, time, and output data.
Page 72