Chapter 2 : Preparations; Preparing A Power Supply; Using A Battery Pack - Sony PMW-500 Operation Manual

Solid-state memory camcorder
Hide thumbs Also See for PMW-500:
Table of Contents

Advertisement

2
Chapter
Preparing a Power
Supply
For safety, use only the Sony battery packs and
AC adaptors listed below.
• BP-GL95/GL65/L60S/L80S Lithium-ion
Battery Pack
• AC power using the AC-DN2B/DN10 AC
Adaptor
CAUTION
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type
recommended by the manufacturer.
When you dispose of the battery, you must obey the law
in the relative area or country.
ATTENTION
Il y a danger d'explosion s'il y a remplacement incorrect
de la batterie. Remplacer uniquement avec une batterie
du même type ou d'un type équivalent recommandé par
le constructeur.
Lorsque vous mettez la batterie au rebut, vous devez
respecter la législation en vigueur dans le pays ou la
région où vous vous trouvez.
VORSICHT
Explosionsgefahr bei Verwendung falscher Batterien.
Batterien nur durch den vom Hersteller empfohlenen
oder einen gleichwertigen Typ ersetzen.
Wenn Sie die Batterie entsorgen, müssen Sie die Gesetze
der jeweiligen Region und des jeweiligen Landes
befolgen.

Using a Battery Pack

When a BP-GL95/GL65/L60S/L80S Battery
Pack is used, the camcorder will operate
continuously for the time shown below.
32

Preparing a Power Supply

Preparations
Model name
Operating time
BP-GL95
Approx. 170 minutes
BP-GL65
Approx. 115 minutes
BP-L60S
Approx. 105 minutes
BP-L80S
Approx. 140 minutes
WARNING
Batteries shall not be exposed to excessive heat such as
sunshine, fire or the like.
AVERTISSEMENT
N'exposez pas les batteries à une chaleur excessive, au
soleil ou près d'un feu par exemple.
WARNUNG
Akkus dürfen keinesfalls übermäßiger
Wärmeeinwirkung ausgesetzt werden, wie z.B.
Sonneneinstrahlung, Feuer o. ä.
Note
The battery pack operating time depends on the
frequency of use of the battery pack, and the ambient
temperature when used.
Before use, charge the battery pack with a charger
suitable for each battery.
For details on the battery charging procedure, refer
to the battery charger operation manual.
Note on using the battery pack
A warm battery pack may not be able to be fully
recharged.
To attach the battery pack
1
Press the battery pack against the back
of the camcorder, aligning the line on
the side of the battery pack with the
matching line on the camcorder.

Advertisement

Table of Contents
loading

Table of Contents