Using Tape 2 Monitor - Integra DTM-5.3 Instruction Manual

Using Tape 2 Monitor

Standby/On
Standby
Speakers
A B
Zone 2 Off
Phones
Unless the component connected to the TAPE 2 connectors is used,
the indicator in the main unit's display should not
T-2 MONITOR
be lit; otherwise, the sound from other sources will not be heard.
If a 3-head tape deck is connected to the TAPE 2 connectors, you
can use the Tape 2 Monitor to monitor the recording.
Notes:
• Even when Tape 2 is not selected as the source (the
indicator is not lit), the source signal is still sent
T-2 MONITOR
to the TAPE 2 output.
• If you select a different input source while listening to the Tape
2 Monitor sound, the
T-2 MONITOR
seconds. However, the audio signal does not change.
Monitoring during recording
You can monitor the source signal through the speakers or
headphones when Tape 2 Monitor is turned off.
If the indicator in the display is not lit, the sound
T-2 MONITOR
from the source should be audible. If a 3-head tape deck connected
to the TAPE 2 connectors is used for recording, press either the
Tape 2 button on the remote controller or the Tape 2 Monitor but-
ton on the main unit. "TAPE 2" will appear in the display for a few
seconds: the
T-2 MONITOR
you just recorded will be audible.
To return to listening to the source sound, press either the Tape 2
button on the remote controller or the Tape 2 Monitor button on the
main unit. The
T-2 MONITOR
Tape 2 Remote controller
Monitor
or
26
1 ABC
4 JKL
7 STU
Direct Tuning
Display Direct Tuning
Tape 2
DVD Video Monitor Tape 1 FM AM
Tape 2 Monitor
indicator flashes for a few
indicator will light up and the sound
indicator turns off.
T-2 MONITOR
Master Volume
2 DEF 3 GHI
5 MNO 6 PQR
8 VWX 9 YZ-
0/10 / Scan
Clear
Memory FM Mode Character
Bass Treble Balance
Phono CD
L R
DTM-5.3
DTM-5.3
AMP.
Playback
Tape deck (TAPE 2)
or Graphic Equalizer
Using a graphic equalizer
1 Connect the graphic equalizer to the TAPE 2 connectors on
the rear panel of the DTM-5.3.
2 If a second tape deck is used, connect it to the tape deck con-
nectors on the graphic equalizer.
3 Press the Tape 2 button on the remote controller or the
Tape 2 Monitor button on the main unit.
The
T-2 MONITOR
up.
4 Follow the operating instructions for the graphic equalizer.
To record an equalized signal, use the tape deck connected to
the equalizer.
Tape 2
Monitor
T-2 MONITOR
T-2 MONITOR
Recording
indicator on the main unit's display lights
Remote controller
or
Tape 2
Playback
CD player, etc.
T-2 MONITOR