Page 1
DTM-5.3 Ref. No. 3729 SERVICE MANUAL SERVICE MANUAL Apl., 2002 AV RECEIVER DTM-5.3 MODEL Master Volume 1 ABC 2 DEF 3 GHI Standby/On 4 JKL 5 MNO 6 PQR 7 STU 8 VWX 9 YZ- Standby Direct Tuning 0/10 Scan...
Page 2
DTM-5.3 SPECIFICATIONS AMPLIFIER SECTION Image Rejection Ratio: 40 dB Power Output: 100 Watts per channel, min RMS, at 8 ohms, IF Rejection Ratio: 90 dB both channels driven from 20 Hz to 20 kHz, Signal-to-Noise Ratio with no more than 0.08% THD.
Page 3
DTM-5.3 SERVICE PROCEDURES 1. Replacing the fuses This symbol located near the fuses indicates that the fuse used is fast operating type. For continued protection against fire hazard, replace with same type fuse. For fuse rating refer to the marking adjacent to the symbol.
Page 15
DTM-5.3 CAUTION:Replacement for transistor of mark * , if necessary PRINTED CIRCUIT BOARD-PARTS LIST must be made from the same beta group (h ) as the original type. Control terminal PC board (NAETC-7392-1A) Main circuit PC board (NAAF-7395-1A) CIRCUIT NO.PART NO.