Replacing The Batteries In The Remote Control - InFocus LP260 User Manual

Infocus projector user's guide lp260

Hide thumbs Also See for LP260:

Table of Contents

WARNING: Do not drop the

lamp module or touch the glass

bulb! The glass may shatter and

cause injury.

5 Install the new lamp module.

6 Tighten the screws on the outside of the module.

7 Replace the lamp door and the screw.

8 Plug in the power cord and press the

projector back on.

9 To reset the lamp replacement monitor timer, press the

button, select the Setting menu, then navigate to the Lamp

Age option. Press the

replace monitor reset" appears. Select Yes to reset the timer.

See "Using the On-Screen Menus" on page 17 for details

menu navigation.

Replacing the Batteries in the Remote Control

The life of the batteries depends on how often and how long you

use the remote. Symptoms of low battery charge include erratic

responses when using the remote and a reduced range of opera-

tion.

Follow these steps to replace the batteries:

1 Turn the remote face down in your hand.

2 Slide the battery cover off the end of the remote.

3 Remove the old batteries and dispose of them in an environ-

mentally proper manner.

4 Install two new AA alkaline batteries. Make sure you install

each in the correct direction.

5 Slide the battery cover back on the remote.

T r

button, and the message "Lamp

select

button to turn the

power

Table of Contents