Led Indications - Planet WGSW-28040 User Manual

- For 100Base-FX SFP transceiver module: From 2 kilometers (Multi-mode fiber), up to 20/40/60 kilometers
(Single-mode fiber).
■ Console Port
The console port is a DB9, RS-232 male serial port connector. It is an interface for connecting a terminal directly. Through
the console port, it provides rich diagnostic information includes IP Address setting, factory reset, port management, link
status and system setting. Users can use the attached RS-232 cable in the package and connect to the console port on the
device. After the connection, users an run any terminal emulation program (Hyper Terminal, ProComm Plus, Telix, Winterm
and so on) to enter the startup screen of the device.
■ ResetButton
At the left of front panel, the reset button is designed for reboot the Managed Switch without turn off and on the power. The
following is the summary table of Reset button
Reset Button Pressed and Released
< 5 sec: System reboot
> 5 sec: Factory Default

2.1.2 LED Indications

The front panel LEDs indicates instant status of port links, data activity and system power; helps monitor and troubleshoot when
needed. Figure 2-4, Figure 2-5 & Figure 2-6
WGSW-28040 LED indication
■ System
LED Color
PWR Green
SYS Green
functions:
Function
Reboot the Managed Switch
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。
。
。
。
。
shows the LED indications of these Managed Switches.
Figure 2-4 WGSW-28040 LED panel
Lights to indicate that the Switch has power.
Lights to indicate the system is working.
User's Manual of WGSW-28040 / 28040P / 28040P4
Default Username: admin
Default Password: admin
Default IP address: 192.168.0.100
Subnet mask: 255.255.255.0
Default Gateway: 192.168.0.254
Function
24