Factory Default - Planet WGSW-28040 User Manual

4.16.4 Factory Default

You can reset the configuration of the stack switch on this page. Only the IP configuration is retained. The new configuration is
available immediately, which means that no restart is necessary. The Factory Default screen in
Buttons
: Click to reset the configuration to Factory Defaults.
After the "Factory" button be pressed and rebooted, the system will load the default IP settings as following:
。
Default IP address: 192.168.0.100
。
Subnet mask: 255.255.255.0
。
Default Gateway: 192.168.0.254
。
The other setting value is back to disable or none.
To reset the Managed Switch to the Factory default setting, you can also press the hardware reset button
at the front panel about 10 seconds. After the device be rebooted. You can login the management WEB
interface within the same subnet of 192.168.0.xx.
Figure 4-16-4 Factory Default page screenshot
Hardware Reset button
User's Manual of WGSW-28040 / 28040P / 28040P4
216
Figure 4-16-4 appears.