How To Install The Hob - CDA HCC561/1 Manual For Installation, Use And Maintenance

How to Install the Hob

How to install the hob:
Overall dimensions of the hob:
Worktop cut-out dimensions:
1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood
to ensure that you will have the required clearance. The cut-out (Fig.4) shows a 60mm gap from the wall to the cut-out
edge. The distance from the hob, when fitted, to the back wall is 50mm. If a splashback/worktop upstand is to be fitted,
take this into account when cutting the hole. The minimum distance that the hob should be positioned away from the rear
wall or splashback is 50mm.
2. Position the hob seal, as shown in Fig.6, ensuring that the ends meet without overlapping. Do not use silicone type sealant.
3. Secure the hob to the worktop using the fixing brackets and screws supplied, as shown in Fig.7. Remove any excess sealant
after tightening the brackets. Do not over-tighten the fixing brackets.
185mm
150mm
190mm
Fig.4
Fig.6
Width: 580mm Depth: 510mm
Width: 560mm Depth: 490mm
60mm
65mm
480mm
470mm
560mm
550mm
185mm
150mm
190mm
Fig.5
Fig.7
3cm
4cm
8