Care And Maintenance - CDA HCC561/1 Manual For Installation, Use And Maintenance

Care and Maintenance

Always disconnect the appliance from the power supply before undertaking any cleaning or maintenance.
You should use a non-abrasive cleaner to clean the hob top. Any abrasive cleaner (including Cif) will scratch the surface and
could erase the control panel markings.
Types of residues
Light
Accumulated baked-on stains/
dirt, sugar spills or melted plastics
Rings and hard water residues
9
Important:
• Steam cleaners must not be used when cleaning this appliance.
Mains electrical voltage:
Total rated electrical consumption:
If your Hob is not working:
1. Check that the control knobs are switched on.
2. Check that the mains supply has not been switched off.
3. Check that the fuse in the spur has not blown.
Contact CDA Customer Care
A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
5
Clean with
Cleaning sponge and soft cloth
Cleaning sponge or glass scraper
and soft cloth
White vinegar and soft cloth
fast frying steaks
230 - 240 Vac
5.8 kW
Cleaning advice
Wipe over the zone to be cleaned with a sponge and hot
water, and then wipe off with a soft dry cloth.
Wipe over the zone to be cleaned with a sponge and hot
water, using a ceramic scraper to remove any large marks
or stains and then wipe off with a soft dry cloth.
Pour a small amount of warm white vinegar onto the stain,
leave it to stand, and then wipe off with a soft dry cloth.