Setting The Bios Configuration Jumper Block; Bios Configuration Jumper Block Location; Jumper Settings For The Bios Setup Program Modes - Intel D815EGEW Product Manual

Intel Desktop Board D815EGEW Product Guide

Setting the BIOS Configuration Jumper Block

CAUTION
Always turn off the power and unplug the power cord from the computer before changing the
jumper. Moving the jumper with the power on may result in unreliable computer operation.
The location of the board's BIOS configuration jumper block, labeled C6D6, is shown in
Figure 17.
This three-pin jumper block, shown in Figure 17, enables all desktop board configurations to be
done in BIOS Setup. Table 6 shows the jumper settings for the Setup program modes.
Table 6.

Jumper Settings for the BIOS Setup Program Modes

Function/Mode Jumper Setting
Normal
1-2
Configure
2-3
Recovery
None
34
1
3
C6D6
Figure 17. BIOS Configuration Jumper Block Location
Configuration
The BIOS uses current configuration information and passwords
1
for booting.
3
After the POST runs, Setup runs automatically. The maintenance
1
menu is displayed.
3
The BIOS attempts to recover the BIOS configuration. A recovery
1
diskette is required.
3
OM12560