Clearing The Passwords; Jumper Settings For The Usb Ports - Intel D815EGEW Product Manual

Intel Desktop Board D815EGEW Product Guide
Table 8 describes the jumper settings for configuring USB port 0 and USB port 1.
Table 8.

Jumper Settings for the USB Ports

Jumper Setting
1
1-2
1
2-3
1
None

Clearing the Passwords

This procedure assumes that the desktop board is installed in the computer and the configuration
jumper block is set to normal mode.
1. Observe the precautions in "Before You Begin" (see page 21).
2. Turn off all peripheral devices connected to the computer. Turn off the computer. Disconnect
the computer's power cord from the ac power source (wall outlet or power adapter).
3. Remove the computer cover.
4. Find the configuration jumper block (see Figure 17).
5. Place the jumper on pins 2-3 as shown below.
1
3
6. Replace the cover, plug in the computer, turn on the computer, and allow it to boot.
7. The computer starts the Setup program. Setup displays the maintenance menu.
8. Press <Enter> and Setup displays a pop-up screen requesting that you confirm clearing the
password. Select Yes and press <Enter>. Setup displays the maintenance menu again.
9. Press <F10> to save the current values and exit Setup.
10. Turn off the computer. Disconnect the computer's power cord from the ac power source.
11. Remove the computer cover.
12. To restore normal operation, place the jumper on pins 1-2 as shown below.
1
3
13. Replace the cover, plug in the computer, and turn on the computer.
36
Configuration
3
Allows wake from ACPI state S1
3
Allows wake from USB ports in all ACPI states
(must also set ACPI BIOS option to S3)
3
USB ports will not function