Table of Contents
Advertisement
Heart rate zone menu screen
Heart rate sensor ID
This function allows the ID signal transmitted by the heart rate sensor to be received and
checked.
Before checking HR sensor ID, mount the main unit to the HR receiver.
NOTE: Be sure to attach the main unit to the HR receiver. Signals from the heart rate sensor
cannot be received by the main unit alone.
Within 5 minutes of pressing the START/STOP/ENTER button, place the HR sensor approxi-
mately 20-80 cm from the main unit and press the reset button on the HR sensor for five
seconds to transmit the ID signal.
When the main unit receives the ID signal, the ID check has been completed.
1
MODE-
You can view the ID number but cannot reset it while the bicycle is in motion.
2
MODE-
NOTE: • Failure to receive the ID signal within five minutes or the pressing of the START/
STOP/ENTER button cancels the heart rate sensor ID set mode, leaving the ID as it
was.
• The minimum transmission of the heart rate sensor is 20 cm. The signal will be too
strong to perform the heart rate sensor ID check if the chest strap is within 20 cm of
the main unit.
• When two or more users with this unit ride side by side with the same ID, interfer-
ence can occur and correct measurement may be impeded. In such a case, change
the ID using the following the steps below:
Heart rate sensor ID menu screen
After ID checking, the ID viewing screen reappears automatically.
Present ID number
1
MODE-
2
MODE-
Data file menu screen
38
CC-TR100
For the basic information on how to use the
menu screen, refer to page 28.
S/S/E
5 Sec
Heart rate sensor reset button
ID standby screen
S/S/E
Cancel
Haert rate sensor ID menu screen
Data file
You can check and manage data files recorded by the TR100.
Display 1 indicates the remaining amount of storage (%). Display 3 indicates the total number
of laps used in that data file. Display 4 indicates the data file number.
NOTE: • To view and use the contents of the stored data files, the optional download kit (and
or power unit) is required.
• When there are no date files recorded ("F-0" on Display 4), this screen cannot be
operated.
• Checking data files
You can check data files by pressing the START/STOP/ENTER button.
The screen displays the data file number, recording interval, memory consumption, number
of laps, date and time when the file was recorded, and exercise duration.
1
MODE-
To switch the data file number, press MODE-1 or MODE-2.
2
MODE-
NOTE: • Up to 99 data files can be stored until the remaining memory is at 0%.
• When the remaining memory reaches 0% while data storge is in progress, your
data file will end at that point. Measurement continues, however, data is no longer
stored in a data file. New data files will not be created.
• When data is transferred to a personal computer using the optional download kit,
"move data" is performed and the data files are deleted from the TR100.
("Move data" can be changed to "Copy data". For details, see the instruction manual
for the download kit.)
Data file menu screen
Remaining memory
Memory consumption
Data file
number
Number of
S/S/E
laps used
in file
Number of laps used
Data file check screen
MODE-
1
2
MODE-
Data storage menu screen
For the basic information on how to use the
menu screen, refer to page 28.
Recording interval
File number
Date of ride
1 or
2
MODE-
MODE-
Switch file
Ride time
Alternating data display
Ride start time
CC-TR100
S/S/E
End
39
Advertisement
Table of Contents
