Configuring Main Unit; Wheel Selection; Tire Circumference Input - Cateye CC-TR100 Instruction Manual

Configuring main unit

When the MENU button is pressed with the Measuring screen displayed, the menu screen appears.
The menu includes a total of 17 screens as shown in the figure below: the main unit settings can be
checked or changed using these screens.
The basic information on how to use the menu screen is as follows:
1. When the Measuring screen is displayed, press the MENU button to switch to "Wheel circum-
ference" of the menu screen.
2. Press the MODE-1 or MODE-2 button until desired menu screen appears.
3. Press the START/STOP/ENTER button to change the settings.
NOTE: For information on how to change various settings, refer to the relevant page as shown below.
4. When the setting change is completed, press the START/STOP/ENTER button to confirm the
setting and return to the menu screen.
NOTE: Make sure to press the START/STOP/ENTER button each time the setting is changed.
Pressing the MENU button cancels the setting.
5. Press the MENU button to return to the Measuring screen.
NOTE: After one minute idle, menu screen will return to the Measuring screen.
Menu screens at
a glance

Wheel selection

Tire circumference input

1
MODE-
See page 29 See page 29
MENU
Power select 2
MODE-
*1: If you select "on" for Power Select on
*1
Main display
See page 43
*2: This menu is available when the op-
Torque *2
*3: This menu is displayed when Power
PC Link *2
*4: To use the data files recorded in this
See page 42
Data storage *4 Data file *4
Heart rate sensor ID
See page 41 See page 39 See page 38
28
CC-TR100
Auto-mode Sound
See page 30 See page 30
the menu screen, the main display
will switch to torque measurement/
See page 31
power calculation.
tional download kit and/or power unit
Manual odometer input
is used.
Select and Data Storage are turned on.
Initially, it is not displayed as the de- See page 32
fault setting for Power Select is off.
To use these functions, the optional
power unit is required.
menu, the optional download kit or
power unit is required.
See page 32
Heart rate zone Cadence zone
See page 36 See page 34
Power select menu screen
1
MODE-
2
MODE-
Wheel selection menu screen
Date
See page 31
1
MODE-
Setting clock
2
MODE-
Tire circumference input menu
screen
Speed unit
1
MODE-
2
MODE-
Defining remote
button setting
See page 33 Auto-mode menu screen
For the basic information on how to use the
menu screen, refer to page 28.
Wheel selection
You can choose between two wheels, A and B. The initial value for tire size (circumference) B
is 2050 mm.
NOTE: • Before Wheel circumference, it is necessary to stop the measurement and reset all
measured data.
• Not resetting all measured data causes the "PLEASE rESEt" message to be displayed,
making selection impossible.
S/S/E S/S/E
Select
1 or 2
MODE- MODE-
Tire circumference input
You can change the tire circumference selected in "Wheel selection" (wheels A or B). You can
view data, but cannot alter it while the bicycle is in motion.
NOTE: • Before tire circumference input, it is necessary to stop the measurement and reset
all measured data.
• Not resetting all measured data causes the "PLEASE rESEt" indication to be dis-
played, making selection impossible.
• Specifying a numerical value outside the setting range causes the "Error" indication
to be displayed, making selection impossible.
2
MODE-
1
MODE-
Digit shift
S/S/E
1
MODE-
Changing numerical values
2
MODE-
S/S/E
Select
Changing numerical values
29
CC-TR100