Cateye Padrone Smart+ CC-SC100B Quick Setup Manual
Hide thumbs
Also See for Padrone Smart+ CC-SC100B:
- Online manual (154 pages) ,
- Start manual (2 pages) ,
- Start manual (2 pages)
Related Manuals for Cateye Padrone Smart+ CC-SC100B
Summary of Contents for Cateye Padrone Smart+ CC-SC100B
- Page 1 Padrone Smart Quick Set -up Guide...
- Page 2 1. Format the computer EMOVE INSULATION SHEET FROM BATTERY COMPARTMENT PRIOR B. Press and release the mode bu9on once to A. Press and release the AC bu9on on the back on select “format,” then press and hold the mode the smart+ computer. bu9on for 2 seconds to format the smart+ computer.
- Page 3 2. Launch the Cateye Cycling App A. Open the Cateye Cycling app on your iPhone or Android device. Press the menu bu9on on the upper leF hand corner of the screen and turn connect ON. B. Click on ‘Se<ngs’ and enable Bluetooth on your smartphone.
- Page 4 3. Pair smart computer to the Cateye Cycling App B. Click on ‘pairing’ to connect the smart computer A. From the menu screen in the app, click on device, to the Cateye Cycling App. The smart computer and then press the blue ‘Pair to Device’ bu9on at will appear in the device screen with a blue the bo9om of the screen. check-mark once it is connected to the app.
- Page 5 4. Pair and configure the sensors D. Scroll up or down with your finger to select the A. Return to the device pairing screen , , Ure circumference value when an ISC-12 device and press the blue “pair to device” sensor is paired with the Cateye Cycling App. bu9on. B. Pass a magnet across the sensor, wear the HR monitor, or rotate the cranks to trip the sensor(s). C. Click “pairing” to pair the sensor(s).
- Page 6 5. Configure the units of measurement A. Return to the main menu screen by B. Click on ‘units’ and select the desired units of measurement. pressing and click on ‘General’ under the SeXng tab.
- Page 7 6. Update Padrone Smart firmware C. New firmware will be downloaded to the pressing A. Return to the device pairing screen by app, and then pushed onto the smart+ , , device and then click on Padrone computer. Smart+1. D. The smart+ will restart once the update is B. In the device sub-menu, click on ‘update complete. firmware.’...
- Page 8 7. StarMng a ride (from the app) B. Press the recording bu9on at the bo9om of the A. Return to the main menu screen by pressing trip screen to begin recording a ride. The screen [ , and then press the ‘Trip’ bu9on above will change to say ‘recording’ once a ride is in the acUvity tab. progress.
- Page 9 8. StarMng a ride (from the smart computer) A. Following step 9, press and hold the SS/Lap B. The screen state will change from ‘ready’ to bu9on for 1 second or unUl the smart+ display the ride data once a ride has been computer beeps once to begin recording a ride. started.