®
Invacare
Electra
9.1.3
Components involved
A
Panelling (chapter: 9.3 page: 19
9.1.4
Reassembly information
Before disassembling the seat unit, mark the height of the seat attachment (3.4), the backrest and the
armrest width settings.
9.1.5
Reassembly information for "removing seat unit""
•
Pull release lever(1).
•
Turn the seat unit by about ¼ revolution to the right or left (2) and remove
the seat unit upwards out of the seat attachment.
9.1.6
Reassembly information for "removing seat tube"
•
Loosen the clamp lever and remove seat tube.
9.1.7
Reassembly information for "replacing seat unit"
•
Place the clamp (1) on the seat tube (2).
The clamp opening (a) must be in alignment with the slot in the seat tube
(b).
•
Push the seat tube (3) into the attachment tube and turn until the guide
groove (c) noticeably locates into the seat tube anti-turn device
•
Tighten clamp (4).
Page 16
Service Manual
Removing seat unit (top
view)
Making the clamp fast
Pushing in seat tube
As at:15.04.02