Drive Components; Replacing Drive Motor; Seat System; Replacing Seat Suspension / Spring - Invacare Colibri Service Manual

Invacare® Colibri
Fig. 4-23
Removing Wheel
1. Loosen and remove nut (2).
2. Remove bolt (1).
3. Pull wheel (3) out of bracket.
4. Replace wheel.
Installing Wheel
1. Install parts in reverse order. Tighten self-locking
nut just tight enough that the wheel can still rotate
without resistance.
2. Test all functions.

4.9 Drive components

4.9.1 Replacing Drive Motor

CAUTION!
Risk of Accident
When parking the scooter on the scooters
support wheels it is no longer slowed by motor
brake. The scooter can roll away out of control.
– Place the scooter rear frame on a supporting
wooden block before you remove the wheels.
CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure scooter against rolling away.
When removing, note position of small parts such
as screws and washers. Put small parts down so
that they can be installed in correct sequence.
Plugs on power module cannot be wrongly
connected because all plugs have a different size
and only fit in one socket.
• 8 mm wrench
• 13 mm wrench
• Phillips screwdriver
• Rubber hammer
• Supporting wooden block
• Cable ties
1. Remove seat.
2. Remove battery boxes.
3. Remove drive unit.
4. Support drive unit with a wooden wedge.
18
5.
Loosen and remove fixing bolts (1), (2) and (3) on
rear shroud.
6. Remove rear shroud.
7.
Loosen and remove screws (2) and counter them.
8. Unplug drive motor plug (1) of socket strip.
9. Fold drive to rear onto chassis and anti-tipper wheels.
10. Loosen fixing screws of rear wheels.
11. Remove wheels, see 4.8.2 Replacing Wheels (4–Wheel
Version / Rear Wheels of 3–Wheel Version), page 16.
12. Remove motor downwards out of mobility device
frame.
13. Replace motor.
14. Install parts in reverse order.
Install motor plug floating. This means you should
ensure that the plug still has little play after the
bolts have been tightened. Tighten bolts to max.
1.5 Nm.
15. Secure motor cable with cable tie.
16. Complete installation of mobility device.
17. Test all functions.

4.10 Seat system

4.10.1 Replacing Seat Suspension / Spring

CAUTION!
Risk of accident
Accidental rolling can lead to accidents.
– Secure scooter against rolling away.
When removing, note position of small parts such
as screws and washers. Put small parts down so
that they can be installed in correct sequence.
Fig. 4-24
Fig. 4-25
1577883-B