Slipper Clutch Installation; Motor Installation - Traxxas Rustler 3701 Assembly Manual

SLIPPER CLUTCH INSTALLATION:

STEP A-26
Locate the 84-tooth spur gear, two pressure plates, two notched, pressure
rings, six friction pegs, the spur gear bushing, the slipper tension spring and
a 4mm locknut.
BANDIT:
Use the 78-tooth spur gear instead of the 84-tooth spur gear that is pictured.
STEP A-27
Install a pressure plate onto the top gear shaft with the small, gold pin facing
out. Place one of the pressure rings over the pressure plate. Install the
pressure ring with the flat side against the pressure plate. Align the notch in
the pressure ring with the pin.
STEP A-28
Slide the spur gear bushing onto the top gear shaft. Install the spur gear. It
should fit snugly onto the bushing. Insert a friction peg into every other,
inner hole on the spur gear (as shown below). Place the other pressure ring
on top of the spur gear (beveled side against the spur gear pegs).
STEP A-29
Install the other pressure plate as shown. Align the pin in the pressure plate
with the notch in the pressure ring. Slide the spring over the top gear shaft
and secure the assembly with the 4mm locknut.

MOTOR INSTALLATION:

STEP A-30
Locate the motor, two 3x8mm washerhead machine screws, the 18-tooth
pinion gear, and a 3mm grub screw.
BANDIT:
Use the 25-tooth pinion gear instead of the 18-tooth pinion gear that is pictured.
9