Rear Suspension Arms - Traxxas Rustler 3701 Assembly Manual

Left
11
STEP A-36
Fasten the two rear camber links to the lower holes in the shock tower with
the 3x12mm shoulder screws and 3x6mm flat washers. Insert the washer
between the shoulder screw and the shock tower.
STEP A-37
Position the rear shock tower on top of the gearbox as shown. Fasten the
shock tower to the gearbox with two 3x12mm roundhead self-tapping
screws. The transmission assembly is now complete.

REAR SUSPENSION ARMS:

STEP B-1
Locate the left and right rear suspension arms, the rear stub axle carriers,
two 46mm screw pins, two 28mm screw pins, two 3x12mm ball screws, four
5x8mm oilite bushings, and two 3x6mm flat metal washers. The washers are
located in bag H. Remove any mold flashing that may still be attached to
the parts.
BANDIT:
The Bandit rear suspension arms are shorter than the Rustler arms.
Right
Screw pin
STEP B-3
Insert the oilite bushings into the stub axle carriers. Place a drop of 3-in-1
Oil™ on each bushing.
STEP B-2
The suspension arms are labeled L and R to
"R" designate left and right. Position the left and right
suspension arms onto the mounts of the gearbox
as shown. Insert a 46mm screw pin through the
pivot points on each suspension arm. Tighten the
screw pins until they are snug, but not tight
enough to bind the suspension arm.