Drive Shaft Completion - Traxxas Rustler 3701 Assembly Manual

Washer
STEP B-4
Position a stub axle carrier, as shown, on the end of each of the suspension
arms. Note that the stub axle carrier has two pivot points. Use the top hole.
Insert a 28mm screw pin through the pivot points on each arm. Do not
overtighten. Slide a 3x6mm washer over each of the 3x12mm ball screws.
Insert the screws into the fourth hole (counting from the inside out) of each
rear suspension arm.

DRIVE SHAFT COMPLETION:

STEP B-5
Locate the two internal-splined halfshafts, the two stub axles, two metal
u-joint balls, and the u-joint assembly wrench (leftover from bag A).
STEP B-6
Insert one pin of the metal u-joint ball into one side of the internal-
splined halfshaft.
STEP B-7
Use the u-joint assembly wrench to insert the opposite pin into the halfshaft.
Try to exert force down and to the left (as viewed in the photo), in order to
spread both sides of the halfshaft yoke equally.
STEP B-8
Insert one of the remaining u-joint pins into the stub axle
yoke. Use the u-joint assembly wrench to insert the opposite
pin into the stub axle yoke. Exert force down and to the left
in order to spread both sides of the stub axle yoke equally.
12