Speed Control - Traxxas Rustler 3701 Assembly Manual

SPEED CONTROL:

STEP F-9
Locate the rotary mechanical speed control, resistors, resistor cover, two
3x23mm roundhead machine screws, two 3x12mm washerhead self-tapping
screws and a 3x12 roundhead self-tapping screw. Remove the speed control
from the bag and untangle the wires. In the photo, the speed control is
shown in its neutral position (between forward and reverse). It should be in
this position when turned over and pressed onto the throttle servo.
STEP F-10
Position the speed control on top of the throttle servo
and push it down onto the throttle servo output shaft.
Secure the speed control with two 3x12mm washerhead
screws.
NOTE: The servo horn on the speed control is
compatible with Traxxas/ Futaba radios. When
using other brand radios, use the servo horn which
comes with your radio system.
STEP F-11
Insert a 3x12mm roundhead self-tapping screw into the shock tower just
above the speed control. Do not tighten the screw all the way, as shown. This
screw prevents the speed control from lifting off the servo.
STEP F-12
Place the two resistors in the aluminum cover, as
shown. Fasten the back with a 3x6mm roundhead
machine screw and 3mm nylon locking nut
STEP F-13
Attach the resistor pack to the top of the transmission with two 3x23mm
roundhead machine screws.
24