Front End Assembly; Shock Installation - Traxxas Rustler 3701 Assembly Manual

FRONT END ASSEMBLY:

STEP F-19
Position the front suspension assembly onto the front of
the chassis as shown. Attach the front suspension to the
chassis with three 4x12mm countersunk machine screws
from the underside.
STEP F-20
Locate the upper chassis plate assembly, two 4x15mm countersunk machine
screws, two 3x12mm washerhead machine screws and two 3x12mm
countersunk self-tapping screws.
STEP F-21
Position the upper chassis plate assembly on the chassis as shown. Attach it
in the front with the two 4x15mm countersunk machine screws and in the
rear with the two 3x12mm countersunk self-tapping screws.
STEP F-22
Attach the outer ends of the tie rods to the steering blocks with the two
3x12mm washerhead machine screws.

SHOCK INSTALLATION:

STEP F-23
Locate the two rear XX-long shocks (the two longest
ones), two 3x12mm shoulder screws, and two 3x6mm flat
metal washers. Insert the shoulder screws through the
shock caps and then slide a 3x6mm flat metal washer
over the end of each shoulder screw. Screw the shoulder
screws into the holes in the shock tower.
26