Bag C Front Suspension - Traxxas Rustler 3701 Assembly Manual

Washer
Front View
13
STEP B-9
Insert the external-splined halfshaft into the internal-splined halfshaft.
Next, insert a greased stub axle through the stub axle carrier. Repeat for the
opposite side.
STEP B-10
Attach the free end of the camber link to the stub axle carrier with a 3x12mm
shoulder screw and a 3x6mm flat metal washer. Repeat for the other stub
axle carrier and camber link. The rear suspension is complete.

BAG C FRONT SUSPENSION:

STEP C-1
Locate the front bulkhead, the front shock tower, and two 3x15mm
washerhead self-tapping screws.
Back View
STEP C-3
Locate the two front suspension arms, the left and right caster blocks, two
40mm screw pins, and two 24mm screw pins. Remove any mold flashing that
may have remained on the parts.
BANDIT:
The Bandit front suspension arms are slightly shorter than the Rustler arms. The
Bandit also uses two 31.5mm suspension pins with E-clips instead of screw pins.
STEP C-2
Attach the shock tower to the back of the front bulkhead
with the two 3x15mm washerhead self-tapping screws.