Throttle Servo; Transmission Installation - Traxxas Rustler 3701 Assembly Manual

OUTPUT

THROTTLE SERVO:

SHAFT
STEP F-4
Locate your throttle servo (not included in the kit) and four 3x8mm
washerhead self-tapping screws. Center your throttle servo as described in
your radio system's instructions. Install the throttle servo in the chassis.
Position the output shaft as shown and secure the servo with the four
3x8mm washerhead self-tapping screws. Route the throttle servo cable
neatly to the receiver and plug the connector into the channel 2 receptacle.

TRANSMISSION INSTALLATION:

STEP F-5
Locate the transmission assembly, two 3x12mm countersunk self-tapping
screws, four 4x12mm countersunk machine screws, and two 3x12mm
roundhead self-tapping screws.
STEP F-6
Place a piece of electrical or plastic tape over the hole in the bottom of the
gearbox. This will prevent dirt from entering.
STEP F-7
Position the transmission on the rear of the chassis as shown. Insert two
3x12mm roundhead self-tapping screws, through the bottom of the rear
shock tower, into the chassis.
STEP F-8
Turn the chassis over and insert a 4x12mm countersunk machine screw into
each location indicated by the #1 arrows. Insert a 3x12mm counter-sunk self-
#2
#2
tapping screw into each location indicated by the #2 arrows.
#1
23