Bag G Wheels, Tires, Axles - Traxxas Rustler 3701 Assembly Manual

27
STEP F-24
Snap the bottom of each rear shock over the ball screws in the rear
suspension arms.
STEP F-25
Locate the front shocks, the two remaining
3x12mm shoulder screws, two 3x6mm flat metal
washers, and two 3x15mm roundhead machine
screws. Attach the shocks to the shock tower by
inserting the shoulder screws through the shock
caps, sliding a 3x6mm flat metal washer over
each shoulder screw and screwing the shoulder
screws into the front shock tower.
STEP F-26
Attach the front shocks to the front suspension arms by inserting the end of
each shock into the suspension arm and securing it in the outside holes with
3x15mm roundhead machine screws.

BAG G WHEELS, TIRES, AXLES:

STEP G-1
Locate the front and rear tires and wheels. The front Rustler wheels can be
identified by their deeper offset (dish). Stretch the ribbed front tires over the
front wheels and the spiked rear tires over the rear wheels. On all tires, make
sure the bead of the tire is fully seated in the groove of the wheel.
BANDIT:
Stretch the front and rear knobby tires over the front and rear
rims, make sure the bead of the tire is fully seated in the rim.
You may glue the tires by pulling the bead back with your
thumb and placing a drop of superglue in several places
around the tire.
STEP G-2
Locate two axle pins, hex hubs, 4mm locknuts
and 5x8x1.0mm plastic washers. Slide one of the
plastic washers over a stub axle. Now, insert the
axle pin into the hole in the stub axle.