Integra DTM-40.4 Instruction Manual page 46

Zone 2
—Continued
Controlling Zone 2 with the Remote
Controller
To control Zone 2, you must press the remote
controller's [Zone2] button first.
M
Input
Selector
1 Press the [Zone2] button, then point the
remote controller at the receiver and press
the [] button.
Zone 2 turns on and the Z2 (Zone 2) indicator
appears.
2 To select an input source for Zone 2, press
the [Zone2] button, followed by an Input
Selector button.
To select AM or FM press the [Tuner] Input
Selector button repeatedly.
Note:
• You cannot select different AM or FM radio sta-
tions for your main room and Zone 2. The same
AM/FM radio station will be heard in each room.
• Similarly, you cannot select the NET and USB
inputs separately for the main room and Zone 2.
3 To turn off Zone 2, press the [Zone2] button,
followed by the [] button.
46
En-
Zone2
Main
Volume F/H
Muting
Z2 (Zone 2) indicator
Adjusting the Volume of Zone 2
Press the receiver's [Zone 2] button, and then use the
[Master Volume] control, or remote controller's [Zone2]
button, and then use the Volume []/[] buttons.
Muting Zone 2
On the remote controller, press the [Zone2]
button, and then press the [Muting] button.
To unmute Zone 2, press the remote controller's
[Zone2] button, and then press the [Muting] button
again.
Notes:
• Zone 2 can also be unmuted by adjusting the volume.
• The Zone 2 level, balance, and tone functions have no
effect on the ZONE 2 PRE OUT when the Zone 2 Out

setting is set to Fixed (
• To control the volume and mute of the receiver in the
main room, press the remote controller's [Main]
button and then perform the desired operation.
Checking the Source Selected for Zone 2
Press the [Zone 2] button on the receiver itself.
The display will show the name of the selected source.
Zone2
Muting
page 42).