Setting The Display Brightness; Using The Sleep Timer (Remote Controller Only); Using The Tone And Balance Controls; Select The Audio Input - Integra DTM-40.4 Instruction Manual

Enjoying Audio Sources
Dimmer

Setting the Display Brightness

You can adjust the brightness of the display.
Press the remote controller's [Dimmer] button
repeatedly to select: dim, dimmer, or normal
brightness.
You can also use the receiver's [Dimmer] button (North
American model).
Using the Sleep Timer
(remote controller only)
With the sleep timer, you can set the receiver so that it
turns off automatically after a specified period.
Press the remote controller's [Sleep] button
repeatedly to select the required sleep time.
You can set the sleep time from 90 to 10 minutes in 10
minute steps.
The SLEEP indicator appears on the display when the
sleep timer has been set, as shown. The specified sleep
time appears on the display for about 5 seconds; then the
previous display reappears.
To cancel the sleep timer, press the [Sleep] button
repeatedly until the SLEEP indicator disappears.
To check the remaining sleep time, press the [Sleep]
button. Note that if you press the [Sleep] button while the
sleep time is being displayed, you'll shorten the sleep
time by 10 minutes.
20
En-
—Continued
Mode
Sleep
SLEEP Indicator
Bass
Dimmer
(North American model)

Using the Tone and Balance Controls

This section explains the following functions that can be
used with any input source.
Adjusting the Bass
The Bass control adjusts bass sounds.
Turn it up to make them louder. Turn it
down to make them quieter. Normally, it
should be set midway.
Adjusting the Treble
The Treble control adjusts treble sounds.
Turn it up to make them louder. Turn it
down to make them quieter. Normally, it
should be set midway.
Adjusting the Balance
The Balance control is used to control
the relative volume level of the left and
right speaker systems.

Note:

If headphones are connected, the
Balance control has no effect.

Select the Audio Input

If a digital source is being input, the input selection will
automatically switch to digital.
Treble
Balance