Advanced Setup Menu - Integra DTM-40.4 Instruction Manual

Advanced Setup
—Continued

Advanced Setup Menu

1. Digital Audio Input
If you connect a component to a digital audio input, you
must assign that input to an input selector. For example,
if you connect your CD player to the OPTICAL IN 1,
you must assign "OPTICAL1" to the "CD" input
selector.
Here are the default assignments.
Input selector
BD/DVD
VCR/DVR
CBL/SAT
Game
TV/Tape
CD
Phono
Port
COAXIAL1, COAXIAL2, OPTICAL1,
OPTICAL2:
Select the corresponding digital audio input, to
which the component has been connected.
–––––:
Select if the component is connected to an analog
audio input.
Notes:
• Available sampling rate for PCM signals from a
digital input (optical and coaxial) is 32/44.1/48/88.2/
96 kHz/16, 20, 24 bit.
• If you connect a component (such as a UP-A1 Dock
with an iPod inserted) to the UNIVERSAL PORT
jack, you cannot assign any input to the Port selector.
2. Source Setup
Intelli Volume
See page 40.
IntelliVolume does not apply for Zone 2.
Name
This changes the name displayed by the Input Selector.
First use the Input Selector to select the name of the
source you want to change, and then use this Setup Menu
to change the name that's displayed. Use the []/[]
buttons to step through the following names.
– – –  Blu-ray  DVD  HD DVD  VCR  DVR
 Tivo  CableSTB  SAT STB  PS3  Wii 
Xbox  PC  TV  CD  TAPE  iPod  – – –
Name Edit
You can edit the name of the radio preset if an FM or AM
preset station is being received. (See page 24)
Default assignment
COAXIAL 1
–––––
COAXIAL 2
OPTICAL 1
–––––
OPTICAL 2
–––––
–––––
3.4.5. 12V Trigger A/B/C Setup
Delay
0sec, 1sec, 2sec, 3sec
When "0sec" is selected, the trigger signal is output as
soon as the input source is changed.
Notes:
• By default, the "12V Trigger A Setup" menu is set to
"0sec", those on the "12V Trigger B Setup" menu is
set to "1sec", and those on the "12V Trigger C Setup"
menu is set to "2sec".
• Use a mini plug cable to connect the receiver's 12V
TRIGGER OUT A, B, or C jack to the 12V trigger
input on a connected component.
BD/DVD, VCR/DVR, CBL/SAT, GAME,
TV/TAPE, TUNER, CD, PHONO, PORT, NET, USB
Off:
No trigger signal is output. A 12-volt trigger signal is
output when the connected component is selected as
the source for:
Main: Main room.
Zone2: Zone 2.
Main/Zone2: Main room or Zone 2.
Note:
• By default, all input sources on the "12V Trigger A
Setup" menu are set to "Main", those on the "12V
Trigger B Setup" menu are set to "Main/Zone2", and
those on the "12V Trigger C Setup" menu are set to
"Zone2"
41
En-