Configuring The Speaker Impedance - Integra DTM-40.4 Instruction Manual

Connecting the Receiver

Configuring the Speaker Impedance

On the receiver, the factory default for speaker impedance is "6
setting, read "Speaker Connection Precautions" on page 10 carefully before performing the procedure below.

 
Setup
12
En-
-Continued
Ω
Note:
Be sure to minimize the volume level on the receiver
before configuring the speaker impedance.
1
2
3
Enter
4
5
Notes:
• This procedure can also be performed on the receiver
• Press [Return] to return to the previous menu.
Setting example :
If you're using only one of the speaker sets connected to
SPEAKERS A or B, choose the 4
speaker's impedance is 4
the 6
more.
If you're using both of the speaker sets connected to
SPEAKERS A and B, choose the 4
speaker's impedance is 8 to 16
". If you need to change the speaker impedance
Press the [] button to turn on the power.
Press the [Setup] button on the remote
controller.
Use the arrow []/[] buttons to select
"6. Hardware Setup," and then press
[Enter].
Change the impedance value to "4
the arrow []/[] buttons.
Press the [Setup] button on the remote
controller to complete the setting.
If you want to change the impedance setting back
to the factory default setting of 6
same procedure described above.
by using [Setup], Tuning []/[], Preset []/[],
and [Enter].
Ω
Ω
setting if each speaker's impedance is 6
Ω
" using
Ω
, follow the
Ω
setting if each
Ω
to less than 6 , or choose
Ω
or
Ω
setting if each
Ω
.