Zone 2 Out Settings; Using Zone 2 - Integra DTM-40.4 Instruction Manual

Zone 2
—Continued

Zone 2 Out Settings

&/(/#/5
Setup
If you have connected your Zone 2 speakers to an amp
with no volume control, set the Zone 2 Out setting to
Variable so that you can set the zone's volume, balance,
and tone on the receiver.
1 Press the [Setup] button.
The setup menu appears on the display.
2 Use the arrow []/[] buttons to select
"7. Zone2 Setup" and then press [Enter].
The Zone 2 Setup menu appears.
3 Use the arrow []/[] buttons to select:
Fixed: The Zone 2 volume must be set on the
amp in that zone.
Variable: The Zone 2 volume can be set on the
receiver.
4
Press the [Setup] button.
Setup closes.

Using Zone 2

This section explains how to turn Zone 2 on and off, how
to select an input source for Zone 2, and how to adjust
the volume for Zone 2.
Controlling Zone 2 from the receiver
Enter
1 To turn on Zone 2 and select an input
source, press the [Zone 2] button
repeatedly.
Alternatively, press the [Zone 2] button
followed by an INPUT selector within 8
seconds.
Zone 2 turns on and the Z2 (Zone 2) indicator
appears.
To select the same source as that of the main room,
press the [Zone 2] button repeatedly until "Zone 2
Selector: Source" appears.
Rotate the Input Selector to select AM or FM.
Notes:
• You cannot select different AM or FM radio sta-
• Similarly, you cannot select the NET and USB
2 To turn off Zone 2, press the Zone 2 [Off]
button.
Notes:
• Only analog input sources are output by Zone 2.
Digital input sources are not output. If no sound is
heard when an input source is selected, check to make
sure it's connected to an analog input.
• While Zone 2 is on, the Auto Power On and Direct
Change RI functions do not work.
Off
Zone 2
Z2 (Zone 2) indicator
tions for your main room and Zone 2. The same
AM/FM radio station will be heard in each room.
inputs separately for the main room and Zone 2.
45
En-