Main Remote Control Unit; Operating Denon Audio Components; Presetting - Denon AVR-1708 Owner's Manual

ENGLISH
."
0;-
<
tT
III " ,..
I
Remote Control Unit Operations
Main Remote Control Unit
IFront]
[MODE
_-----""--"'<:'1r~-
[MODE
SELECTOR 1] ~~~ SELECTOR 2]
[Rear]
Depending on the model and year of manufacture of your equipment,
some buttons may not operate.
43
I
Operati ll 9 D:ENON Audio 'Components .
1
Set
[MODE SELECTOR
1] to "AUDIO".
2
Set
[MODE SELECTOR
2] to the position for the
component to be operated (CD, iPodINETWORK or
TAPElCD-RlMD).
3
Operate the audio component.
*
For details, refer to the component's operating instructions.
*
While this remote control is compatible with a wide range of
infrared controlled components, it may be the case that some
component models cannot be operated with this remote control.
1
Set
[MODE SELECTOR 1]
to "AUDIO" or "VIDEO".
*
Set to the AUDIO side for the CD, iPod/NETWORK orTAPE/CD-R/
MD position, and to the VIDEO side for the DVDNDP. VCR, SAT/
CABLE orTV position. .
2
Set
[MODE SELECTOR
2] to the component to be
registered.
3
Press
[ZONEZ OFF]
and
[MAIN ON]
at the same time.
The indicator starts flashing.
4
Referring to the included list of preset codes, press
[NUMBER]
to input the preset code (a 3-digit number)
for the manufacturer of the component whose signals
you want to store in the memory.
5
To store the codes of another component in the
memory, repeat steps 1 to 4.
• The signals for the pressed buttons are emitted while setting the
preset memory. To avoid accidental operation, cover the remote
control unit's transmitting window while setting the preset memory.
• Depending on the model and year of manufacture, this function
cannot be used for some models, even if they are of makes listed in
the list of preset codes.
• Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
• The preset memory can be set for one component only among the
following: TAPE/CD-R/MD, DVDNDP and SAT/CABLE.
I
OperatitlgPreset,Components)
1
Set
[MODE SELECTOR 1]
to "AUDIO" or "VIDEO".
*
Set to the AUDIO side for the CD, iPod/NETWORK orTAPE/CD-R/
MD position, and to the VIDEO side for the DVDNDP. VCR, SAT/
CABLE orTV position.
2
Set
[MODE SELECTOR
2] to the component you want
to operate.
3
Operate the component.
*
For details, refer to the component's operating instructions.
*
Some models cannot be operated with this remote control unit.