Auto Setup - Denon AVR-1708 Owner's Manual

ENGLISH
Auto Setup
Optimize settings for speakers
In
use
If an error message appears during the measurements, check "Error
Messages '; take the necessary countermeasures, then redo the
measurements
(1I2if'
page 21).
g,$i.
• Do not disconnect the setup microphone until the auto setup
procedure is completed.
• When using headphones, unplug the headphones before starting
the auto setup procedure.
•
)
)
-"
Measurements can be completed even if only taken in 5 positions, but
for better results we recommend taking them in 6 positions.
The listening environment with respect to the listening position
("Speaker size check'; "Crossover Frequency check" and "Room EO
correction") is measured automatically at positions 2 to 6.
o
Press
'1 to select "2nd Start'; then press
<l.
• Measurements for the 2nd point start.
®
Move the microphone to the 3rd point and press
<l.
• Measurements for the 3rd point start.
®
Perform
®
repeatedly.
When "Calculate" is selected at "Step 2'; the speaker system is
analyzed automatically.
"Calculate" is displayed when you complete measurements in 6
points. To complete STEP 2 in 5 or less positions, press '1 to select
"Calculate':
( Step 2 : Measurements
( Step 3 : Calculation
~,
The time required for this analysis depends on the number of speakers
connected. The more the number of speakers, the longer the time
required for analysis.
-u·n.
Do not change the speaker connections or subwoofer volume after
making the measurements.
SF;::..;k
e~-·:
3 . . . . . 4./.1
&l&L
t
Subwoofer
Surround and Surround
back speakers
Front and Center speakers
• If the results are not as expected or if an error message is displayed,
select" Retry" and perform the measurements again.
• If the results of remeasurement are still not as expected or an
error message is displayed, turn off the power switch and check
the speaker connections. Then start measurements again from the
beginning.
( Step 1 : Speaker Detect )
The speaker connection status and the speaker polarities are detected at
the main listening position. At this time, the listening environment with
respect to the main listening position ("Speaker size check'; "Distance
correction'; "Channel level adjustment'; "Crossover frequency check"
and "Room EO correction") is measured automatically at the main
listening position.
Once the measurements are completed, "Sp Detect Check" is
displayed.
Press ENTER to check the results of the speaker detection.
Example: 7.1-channel systems
-------~
-n·n.
• Loud test tones are output during the measurements. Be careful
when measuring at night or when there are small children nearby.
• Do not stand between the speakers and setup microphone or allow
obstacles between them while the measurements are being made.
Obstacles will make it impossible to measure correctly.
• Keep as quiet as possible during measurements. Loud sounds in the
area will make it impossible to measure correctly.
• Operating [MASTER VOLUME] or <VOLUME
+/->
during the
measurements will cancel the measurements.
• Do not change the speaker connections or subwoofer volume after
"Step 1':
)
)
)
)
)
DAuto Setup
The settings are performed automatically.
(Auto setup flow]
t
t
t
t
( STEP3: Calculation
( STEP1: Speaker Detect
( STEP2: Measurements (2 to 6 positions)
( STEPS: Store
( STEP4: Check
Press
<l
to start the Auto Setup and output the test tone.
Start
20