Playing Video And Audio Equipment; Basic Operation - Denon AVR-1708 Owner's Manual

ENGLISH
Turning Off the Sound Temporarily (Muting)
Press
[MUTING].
To cancel, press
[MUTING)
again Muting can also be canceled by
adjusting the master volume.
Listening with Headphones
Plug the headphones into
<PHONES>.
The sound from the speakers and pre-out connectors is automatically
cut.
tN·U.
Be careful not to set the volume too high when using headphones.
Switching the front speakers
Press
<SPEAKER>.
Video Select
Switch video input source while listening to audio signal.
[Operation on the main unitl
Press
<VIDEO SELECT>
until
the desired picture
appears.
i>.Ho cancel, press <VIDEO SELECT> to select "SOURCE':
[Operation on the main remote control unitl
Press
[V. SELECT]
until the desired picture appears.
*
To cancel. press the [V. SELECn button to select "SOURCE':
t~l·u.
• It is not possible to select HOMI input signals.
• When playing HOMI video input signals, the analog video signal of
another input source cannot be selected for the HOM I video output.
Checking the currently playing program source, etc.
Press
STATUS.
The current program source and various settings are indicated on
the display.
Switching the brightness of the display
Press
DIMMER.
*
The brightness of the display can be adjusted in three steps. The
display can also be turned off.
• •
eration
1
Prepare the equipment.
CDLoad the OVO, CO or other software in the player.
(!GT'See the operating instructions of the respective devices.)
(1)To playa video device, switch the monitor input.
(!GT'See the monitor's operating instructions.)
2
Use
SOURCE SELECT
to select the input source.
3
Set
[MODE SELECTOR
1lto "AUDIO" or "VIDEO".
(!2Fpage 43 "Remote Control Unit Operations")
4 Set
[MODE SELECTOR
2] to the component you want
to operate.
5
Start playback.
(!2FSee the operating instructions of the respective devices.)
Listening to FMIAM Broadcasts
Basic Operation
1
Either turn
<SOURCE SELECT>
or press
[TUNER]
to
select "TUNER".
2
Set
[MODE SELECTOR
1] to "AUDIO".
(!GT'page 43 "Remote Control Unit Operations")
3
Press
BAND
to select "FM" or "AM".
4
Tune in the desired broadcast station.
CDTo tune in automatically (Auto Tuning)
Press
[MODE)
to light the "AUTO" indicator on the display, then use
TUNING to select the station you want to hear.
@To tune in manually (Manual Tuning)
Press [MODE) to turn off the display's "AUTO" indicator, then use
TUNING to select the station you want to hear.
• It is also possible to switch to "FM" or "AM" in step 1 by pressing
[TUNER).
• If the desired station cannot be tuned in with auto tuning, tune it in
manually.
• When tuning in stations manually, press and hold
TUNING
to change
frequencies continuously.
36
I