Tub Gasket - GE WCVH4800K Technical Service Manual

7. Remove the 4 Phillips-head screws that attach
the hinge cover to the glass holder.
Hinge Cover
8. Pull the door hinge out of the recess in the glass
holder.
Hinge Cap (1 of 4)
Note: Make sure all 4 hinge caps are installed on the
hinge pins before placing hinge in the recess in the
glass holder.

Tub Gasket

The tub gasket provides a watertight seal between
Door Hinge
the front panel and the outer tub. The front of the
tub gasket is secured to the front panel fl ange by a
spring and wire located in the fold of the gasket. The
back of the tub gasket is attached to the outer tub
lip with a wire and bolt gasket clamp.
To remove the tub gasket:
1. Remove the front panel. (See
Note: The 7-mm gasket clamp bolt uses reverse
rotation to tighten or loosen the gasket.
2. Turn the 7-mm bolt
clamp that secures the tub gasket to the outer
tub lip.
3. Remove the wire and bolt clamp from the tub
gasket.
– 45 –
.)
Front Panel
clockwise to loosen the
Wire and Bolt Clamp
(Continued Next Page)