Tub Gasket (Boot) - GE PFWS4600L0 Technical Service Manual

4. Remove the gasket from the front panel. (See
.)
Door Lock
5. Push and fold the left side of the gasket inside
the wash basket and remove the door hinge.

Tub Gasket (Boot)

The tub gasket provides a watertight seal between
the front of the washer and the outer tub. The
front of the tub gasket is secured to the front panel
fl ange by a spring and wire located in the fold of the
gasket. The back of the tub gasket is attached to the
outer tub lip with a wire and bolt assembly.
To remove the tub gasket:
1. Remove the front panel. (See
2. Pull the steam hose out of the tub gasket.
3. Remove the steam hose nozzle.
Note: When reinserting the steam hose nozzle, be
sure the notch aligns with the gasket cutout.
Steam Hose
Notch
4. Pull the water line nozzle out of the tub gasket.
5. Push the light thru the tub gasket.
Note: When reinserting the water line nozzle, make
sure the nozzle and gasket indents line up.
6. Remove the Phillips-head screw from the
7. Pull the tub gasket off the vent.
8. Loosen the 7-mm bolt that holds the wire and
.)
Front Panel
Note: When installing the wire and bolt assembly,
tighten to a gap of approximately 5/8 inch (as
shown). Do not overtighten.
Steam Hose
Nozzle
– 51 –
Water Line
Nozzle
bracket holding the vent to the tub gasket.
bolt assembly to the outer tub lip. Remove the
wire and bolt assembly from the tub gasket.
Wire and Bolt Retainer
5/8-in. Gap
Indent
Light
Vent
(Continued Next Page)