GE WCVH4800K Technical Service Manual page 55

Error Description
Code
3E4 IPM over
heating
error
tE Water
thermistor
error
dE Door open error
dE1 Door lock error
dE3 Door unlock
error
bE2 Button error
AE Communication
error between
Main and Sub
PBA
SF System Failure
error
DE2 Door Protection
UE Out of Balance
Error
NOTE: It's important to note error codes should only be used to help identify those components which
require testing. Never replace a part based solely on an error code. The control can generate a false error
if the right conditions exist. Use the code only as a reference and always check the component before
replacing.
Action
• Check integrity of the main PCB. Replace if necessary.
• Check integrity of the thermistor. Replace if necessary.
• The door is not closed.
• - Please close the door again as the washer will not function correctly when
the door is left open.
• Check the door DC switch. Replace if necessary.
• The door is not closed.
• - Please close the door again as the washer will not function correctly when
the door is left open.
• If the fault persists and re-appears, replace the door lock switch.
• The door is not closed.
• - Please close the door again as the washer will not function correctly when
the door is left open.
• If the fault persists and re-appears, replace the door lock switch.
• If the fault persists and re-appears, replace the main PCB.
• Check button operation.
• If the fault persists and re-appears, replace the sub PCB.
• Check the integrity of the wiring between the main PCB and sub PCB.
• Clear the fault and run the cycle. If fault persists and reappears, replace the
main PCB.
• Replace the main PBA.
• This occurs if power to the door circuit is on and off continually and
excessive heat is generated.
• Washer was unsuccessful in recovering from an out of balance condition
during the fi nal spin and 34 minutes was added to the cycle timer.
– 55 –