Dispenser Assembly - GE WCVH4800K Technical Service Manual

Dispenser Assembly

The dispenser assembly provides automatic
dispensing of detergent, bleach, and fabric softener
as long as the user fi lls the compartments prior to
starting the washer.
The products added to the dispenser are diluted
with water before they are dispensed into the
wash tub. This is accomplished by the water valves
and a plastic conveyer snapped to the top of the
dispenser to direct the outputs from the valves to
the detergent, bleach, and softener chambers.
The dispenser assembly utilizes 3 tabs that position
the assembly to the left and front braces. A Phillips-
head screw attaches the dispenser to the front
brace.
To remove the dispenser assembly:
1. Remove the top and control panels. (See
Cover and Control Panel.
2. Remove the inlet and the dispenser vent hoses
from the dispenser:
a. Squeeze each clamp and slide it back.
b. If necessary, carefully break each hose loose
by inserting a small fl at blade screwdriver
under the hose to break the seal.
c. Remove the hoses.
Hot Water
Pre-wash
Inlet Hose
Inlet Hose
Guide Pin
Top
)
Main Water
Inlet Hose
Dispenser
Vent Hose
– 31 –
Note: When installing the vent hose, engage the
notch on the hose with the tab on the dispenser
body before fastening the clamp.
Tab
3. Note the location of the 3 tabs, then remove the
Phillips-head screw that attaches the dispenser
to the front brace.
Tab
Tab
Notch
Tab
(Continued Next Page)