GE WCVH4800K Technical Service Manual page 44

Door
The door hinge is attached to the front panel with
2 Phillips-head screws and 3 hooks that engage 3
cutouts in the front panel.
To remove the door components:
1. Remove the 2 Phillips-head screws that hold the
hinge to the front panel. Grasp the door and lift
the hinge 1/4-inch to disengage it from the front
panel.
2. Place the door on a soft, protected fl at surface
so that the door lever faces up. (The door should
rest on the handle side.)
3. Remove the 11 Phillips-head screws that hold
the glass holder to the door frame.
4. Grasp and unsnap the glass holder and glass
5. Turn the door over so that the door handle and
Note: The glass is inserted underneath the door
handle cover and held in place with 4 tabs that are
equally spaced along the inner circumference of
the glass holder. To provide correct glass-to-glass
holder orientation, a cutout on the edge of the glass
engages a notch in the glass holder.
6. Push hinge side of glass holder down, then slide
Door Handle
Glass Holder
– 44 –
from the door frame.
door cover face up.
glass away from the handle cover.
Handle Cover
Tab
Cutout in Notch
(Continued Next Page)