Impex MARCY DIAMOND MD-1559 Owner's Manual page 13

STEP 5 (See Diagram 5 & Cable Loop Diagram)
A.) Attach the 134" Upper Cable (#31) to the open bracket under the front of the
Upper Frame (#4). Note: The Ball Stopper on the cable should be underneath
the Frame.
B.) Attach a Pulley (#60) to the open bracket. Secure it with one M10 x 1 ¾" Allen
Bolt (#69), two Ø ¾" Washers (#80), and one M10 Aircraft Nut (#82).
C.) Draw the Cable over the Pulley through the opening on Front Press base (#11)
towards the back of the machine to the open bracket on the Front Vertical Frame
(#3). Repeat step B above to install a Pulley.
D.) Draw the Cable around the Pulley then pull back towards the opening on the
Front Press Base (#11).
E.) Attach a Pulley to the opening on the Front Press Base. Secure the Pulley with
one M10 x 6 7/8" Allen Bolt (#65), two Ø ¾" Washers (#80), and one M10
Aircraft Nut (#82).
F.) Draw the Cable around the Pulley and through to the open bracket on the back
of Front Vertical Frame (#3). Repeat step B above to install another Pulley.
G.) Draw the Cable around the Pulley then pull the Cable downwards. Attach the
Cable to a Double Floating Pulley Bracket (#16). Install another Pulley. Let the
bracket hanging for now.
H.) Pull the Cable upward to the open bracket on the top of Upper Frame. Attach
two L-shaped Cable Retainers (#84) on top of two Pulleys. Install two pulleys to
the bracket.
I.) Pull the Cable downward between the two Guide Rods to the Selector Rod
(#13). Thread the bolt at the end of the Cable into the opening on top of the
Selector Rod (#13) to secure the Cable.
12