Troubleshooting - Utax CD 1435 User Manual

Troubleshooting

When a problem occurs, first check the following. If the problem persists, contact your dealer or service
representative.
Symptom
Cannot send document.
Cannot perform broadcast
transmission.
Cannot perform encrypted
communication.
Cannot use the remote
switching function.
No print output after
reception.
Cannot receive document.
Cannot receive 2 in 1
reception.
Checkpoint
Is the modular cord
connected correctly?
Is Send error displayed?
Is TX (transmission)
restriction activated?
Is free space available in the
memory?
Are the registrations correct
both at sender and recipient?
Is a pulse line used?
Is the remote switching
number correct?
Did you press the remote
switching number too
quickly?
I s memory forwarding
activated?
Is the modular cord
connected correctly?
Is
Communication error
displayed?
Is RX (reception) restriction
activated?
Are 2 in 1 reception and
duplex reception both set?
10-6
Corrective Action
Connect the modular cord
correctly.
Remedy the cause of error
and send again.
Cancel the TX restriction.
Send after the memory has
free space, or create free
space in the memory.
Double-check the
registrations both at sender
and recipient.
Some phones may transmit
tone signals using buttons.
Refer to the operation
manual of your phone set.
Check the registration.
(Default: 55)
Press the remote switching
number twice slowly.
Check the forwarding
destination.
Connect the modular cord
correctly.
Remedy the cause of error
and ask the sender to retry.
Cancel the RX restriction.
Cancel the duplex printing.

Troubleshooting

Reference
Page
–
Appendix-16
Refer to the
machine's
Operation
Guide.
6-21
4-6
6-29
–
4-16
–
–
–
Appendix-16
6-28
6-35