Fagor “TOUCH CONTROL” Instruction Manual page 15

DESCRIPTION OF TIMER
Assigning and Timing the Heat Source
To carry out the assignation of the timer to a heat source the following steps
must be followed:
With vitro ceramic hob switched on:
1- Choose the required power of the heat source that you wish to time.
2- Switch on the timer. For this act once over the sensor + which corresponds
to the timer. In the timer display appears and appears in the display
of each heat source.
3- Act over the + of the chosen heat source. will flash in the display of said
heat source. At this moment the timer is assigned to the chosen heat source.
4- Choose the desired time acting over the + which corresponds to the timer.
Once these steps have been carried out the assignation sequence of the heat
source timer ends.
The timer will automatically switch itself off, if between each step there is a
time space of over 10 seconds or if you do not choose a length of time.
Once the timer has been assigned to a heat source and the time has been
chosen, the timer will gradually discount the time and the display indicates
at each moment the time remaining to switch off the heat source.
During the timing, in the timed heat source display you can see the selected
power and the (indicating that this heat source is timed) alternatively.
Once the time has passed the heat source will switch itself off, the control
will release a warning acoustic signal and will flash in the timing
display. Acting over any sensor control the warning signal will stop.
Cancelling the timer
Act over the sensor of the timer until is shown on the minute display.
62