Fagor “TOUCH CONTROL” Instruction Manual page 25

3
Place the hob alongside the cavity in
the worktop and connect the power
cable to the electrical socket.
IMPORTANT: Carry out connection
with the power disconnected. There
must be a good grounding connection
and a switch must be provided in an
accessible place to isolate all phases,
with at least 3mm. clearance between
contacts. The makers will not accept responsability for
installations carried out other than as directed here.
It is equipped with a power input cable for high
temperatures.
If a new power input cable is required, installation should
be performed by a technician certificated by the maker.
If the power feed wire is damaged, it must be replaced by
the manufacturer, by the after-sales service or by
authorized personnel for safety reasons.
4
Next insert the hob in the worktop
cavity, pressing down firmly to ensure a
good seal.
5
Fix the 4 clamps underneath the hob to
the 4 corners of the cavity.
(Clamps, brackets and nuts supplied in
acessory bag).
NOTE: This equipment complies with satnadard 82/499/CE on radio interferences.
INSTALLATION
72