Fagor “TOUCH CONTROL” Instruction Manual page 19

OPERATING
Automatic programming 9
(quick heating)
Each control area includes an automatic programming function.
This programming allows the corresponding maximum temperature to be
reached quickly and maintained automatically.
Selection
For hobs with horizontal or vertical hobs, touch sensor + once and it is in
position 9, the corresponding decimal point to 9 will switch itself on.
Touching sensor – of the same zone will decrease to the required level
(levels 3...6 are recommended). In the case of compact control sensors
when placed at the required power level A will flash.
After having reached the automatic heating time a short signal could be
heard and the decimal point will switch itself off. The heat source carries on
work in a conventional manner. In the case of compact control sensors A
will stop appearing.
To cancel the automatic programming touch the - sensor and the decimal
point will switch off.
66