Sharp AL-2051 Operation Manual page 118

SCANNER FUNCTIONS
5
Enter search characters and press the
[OK] key.
You will search the names that were entered for
the destinations. Destinations matching the search
characters will appear. To enter characters, see
"How to enter characters" (p.121).
6
Press the [
destination and then press the [OK] key.
7
Press the [
select the original size and then press the
[OK] key.
The original size changes as follows each time the
[
"A4" → "B5" → "A5" → "8.5x14" → "8.5x13" →
"8.5x11" → "8.5x5.5".
8
Press the [OK] key and then [
select the color mode (COLOR, GRAY and B/W) and exposure
level.
(For the setting, see page 114.)
9
Press the [START] key (
116
] key (
] key (
] key ( ) or [ ] key (
• The [CLEAR] key (
to return to the previous step of the operation. To cancel a scanning
operation and return to the initial state of scanner mode, press the
[CLEAR ALL] key (
• The network scanner function cannot scan both sides of an original
placed in the RSPF.
• The scan settings stored in a scan mode cannot be edited if the scan
mode has been selected for a destination. You can either store the
desired settings in a new scan mode as explained in "Storing
scanning settings - Network Scanning" (p.97) and then edit the
destination settings, or you can cancel the selection of the scan mode
for the destination and then edit the scan mode settings.
• Before performing Scan to E-mail, read "Important points when using
scan to E-mail" (p.141). Take care that the image file is not too large.
• A limit for the size of image files that can be sent using Scan to E-mail
can be set in "Basic settings for network scanning" (p.110) of the Web
page.
) or [ ] key (
) or [ ] key ( ) to
) is pressed:
] key (
) to begin scanning.
) can be pressed during a scanning operation
).
SCAN USING:
S
) to select the
ORIG. SIZE ENTER
A4
) or [ ] key ( ) to